Toshiba e-STUDIO2500c, Service Manual, Page: 153 / 402

6
May 2006 © TOSHIBA TEC e-STUDIO2500c/3500c/3510c SCANNER
6 - 23
[F] Scan motor (M1)
(1) Take off the upper rear cover.
P.2-35 "[Q] Upper rear cover"
(2) Take off the rear cover-1.
P.2-35 "[R] Rear cover-1"
(3) Disconnect 1 connector.
Fig. 6-30
(4) Release the harness from the harness
clamp.
(5) Remove 3 screws and take off the scan
motor with the whole bracket.
Fig. 6-31
Notes:
When installing the scan motor, use the belt
tension jig (spring). The procedure is as fol-
lows.
1. Fix the screw A. (P.6-23 "Fig. 6-31")
2. Temporarily fix the screw B and C.
(P.6-23 "Fig. 6-31")
3. Hook the belt tension jig to the motor
bracket and the flame.
4. The scan motor is pulled by the belt ten-
sion jig. Fix the screw B and then C at the
stopped position.
5. Remove the belt tension jig.
Fig. 6-32
C
Scan motor
A
B
Belt tension jig