3
© 2009 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO181/211
ADJUSTMENT
3 - 15
[E] Top margin
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2) Press [4] [INTERRUPT] [PAPER FEED] (Select from 0: bypass, 1: drawer or 2: PFU.)
[START] (A solid black pattern (whole area) is printed out. Print out 2 sheets in A3/LD size.).
(3) Place the paper printed out in step (2) to cover the whole area of the original glass.
(4) Press [0] and [9] simultaneously to enter the normal mode.
(5) Make a copy at the mode of A3/LD, 100%, Text/Photo and standard drawer of the equipment.
(6) Press [0] and [5] simultaneously to enter the adjustment mode.
(7) Measure the blank area E at the leading edge of the copied image.
(8) Check if the blank area E is within the range of 3 ± 0.5 mm.
(9) If not, use the following procedure to change values and repeat the steps (4) to (8) above.
(Adjustment Mode) (Key in the code [430]) [START]
(Key in a value (acceptable values: 0 to 255))
Press the [INTERRUPT] button (stored in memory). (“AJ” is displayed.)
*The larger the adjustment value is, the wider the blank area becomes (approx. 0.04 mm/step).
Fig. 3-12
E
Feeding direction
Summary of Contents for e-STUDIO181
