December 2000 © TOSHIBA TEC
14 - 15
1600/2000/2500 FUSER UNIT/PAPER EXIT UNIT
Fig. 14-7-15
HR drive gear 1
092
7. Remove 2 screws and detach the fuser
thermofuse.
Fig. 14-7-13
091-1
Fig. 14-7-14
091-2
Fuser thermofuse
Screw
Screw
Heat roller
Fuser thermofuse
assembly
Note:
Attach the fuser thermofuse assembly so
that it is placed at the lowest position, and
make sure that the gap shown in the right
figure is ensured.
[F] HR drive gear 1
(DP1600 series)
1. Remove fuser unit. (See Fig. 14-7-1)
2. Remove heater thermistor. (See Fig. 14-7-2)
3. Remove the housing assembly.
(See Fig. 14-7-7)
4. Remove the heat roller separator.
(See Fig. 14-7-5 and 14-7-5-2)
5. Release the heater cover assembly.
(See Figs. 14-7-8 and 14-7-9)
6. Remove the HR drive gear 1.
Note:
When HR drive gear 1 is replaced, apply
0.1 g of white grease (molycoat HP-300) to
the stud.
Stud
02/01
[G] HR drive gear1/ HR drive gear3
(DP2000/2500 series)
1. Remove fuser unit. (See Fig. 14-7-1)
2. Remove heater thermistor. (See Fig. 14-7-2)
3. Remove the housing assembly.
(See Fig. 14-7-7)
Summary of Contents for DP1600
