December 2000 © TOSHIBA TEC
7 - 29
1600/2000/2500 SCANNER
[H] Carriage 2/mirror 2/mirror 3
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, detach it.
2. If a STP (KK-1600) is attached to the copier,
detach it.
3. Detach the manual pocket.
4. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
5. Detach top cover. (See Fig. 2-6-2)
6. Detach scanner cover.
(See Fig. 2-6-3 and 2-6-4)
7. Detach top cover L. (See Fig. 2-6-5)
8. Detach top cover R. (See Fig. 2-6-6)
9. Release the lamp cable.
(See Fig. 7-8-19 to 7-8-22)
10. Remove carriage 1. (See Fig. 7-8-24)
11. Mount the clip jig to prevent the dislocation of
wire wound on scanner drive shaft and secure
wire.
Notes:
1. When the wire holder clip jig is installed,
do not slide or loosen the wound wire.
2. The wire holder clip jigs are the same time
for the front and rear sides.
3. Be careful when installing the clip jig.
Fig. 7-8-26
12. Loosen 2 screws retaining wire holder.
13. Detach wire on the side where it is hooked and
fixed to scanner frame and release wire from
roller if carriage 2.
Fig. 7-8-27
JIG (wire)
Wire
Scanner
drive shaft
058
059
Wire
Wire
Roller
Wire holder
Screw
Carriage 2
Roller
Wire
Summary of Contents for DP1600
