14
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO555/655/755/855
EXIT/REVERSE SECTION
14 - 11
[E] Exit cover switch [SW5]
[F] Gate solenoid [SOL2]
(1) Take off the left lower cover (= exit cover)
(
P.2-44 "[J] Left lower cover (Exit cover)").
(2) Open the exit/reverse unit. Then disconnect
the connector and release the latch to take
off the exit cover switch.
Fig. 14-14
(1) Take off the left lower cover (= exit cover)
(
P.2-44 "[J] Left lower cover (Exit cover)").
(2) Open the exit/reverse unit. Then disconnect
1 connector, release the clamp and remove 3
screws to take off the gate solenoid.
Fig. 14-15
Note:
The solenoid is normally screwed at the
position A shown in the figure at right.
However, the position of the solenoid can be
adjusted by moving this screw to the position
B when the flap valve of the solenoid is not
pulled enough.
Fig. 14-16
Exit cover switch
Gate solenoid
A
B