e-STUDIO555/655/755/855
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 6
4.2.4
Bypass feed copying
1. A sheet of paper is inserted into the bypass tray.
→
The bypass feed sensor (S27) is turned ON.
→
"Set media type" appears.
→
Select the media type and paper size.
→
"Ready for bypass feeding" appears.
2. Pressing the [START] button
→
"Ready for bypass feeding" changes to "COPYING".
→
The drum, developer unit, transfer belt and fuser roller rotate.
→
The main charger, developer bias and discharge LED (ERS) are turned ON. Each fan rotates at a
high speed.
3. Bypass feeding
→
The bypass pickup solenoid (SOL3) is turned ON. The feed motor (M20) is turned ON.
- The bypass pickup roller is lowered.
→
The bypass feed clutch (CLT4) is turned ON.
- The bypass pickup roller and bypass feed roller start to rotate.
→
Aligning operation
- The paper reaches the registration roller.
- After a certain period of time, the bypass pickup solenoid (SOL3) and bypass feed clutch (CLT4)
are turned OFF.
4. Hereafter, the operation 3) to 6) of "4.2.3 Drawer feed copying with [START] button" is repeated.
4.2.5
Interruption copying
1. Pressing the [INTERRUPT] button
→
The LED "INTERRUPT" is turned ON.
→
The copying operation in progress stops temporarily. Carriage-1 and -2 return to their appropriate
positions.
→
"Job interrupted job 1 saved" appears.
→
The automatic density and reproduction ratio 100% are set. (The set number remains the same.)
2. Selecting the desired copy conditions
3. After interruption copying is finished:
→
When the LED "INTERRUPT" is turned OFF by pressing the [INTERRUPT] button, the
equipment returns to the status before the interruption.
→
"Ready to resume job 1" appears.
4. Pressing the [START] button
→
The copying operation before the interruption resumes.