Toshiba DP-5550, Service Manual, Page: 295 / 404

13
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
FUSER UNIT
13 - 21
[D] IH coil
Notes:
When the web has been replaced, check
the following items.
1. When the web pushing roller has been
replaced, reel the web for 3 to 5 turns
by hand.
2. Check if the cleaning web is tightly
reeled after it has been installed in the
fuser unit.
3. Turn the jam access knob of the fuser
unit for 10 to 15 times to fit the web and
the fuser roller.
4. Check if there are not any slacks or
creases on the cleaning web.
5. Start the PM Support Mode (6S) to
reset the counter of the cleaning web.
At the first power-ON after this counter
reset, the web motor rotates for 65
seconds.
6. Turn the power of the equipment ON.
Then confirm that the message
"READY" has appeared on the touch
panel.
7. Perform the final check of the fuser unit
(cleaning web), the same checking as
Step 4.
8. When the web motor is rotated at the
output check in the Test Mode (03-124),
the cleaning web may be slackened. Do
not rotate the motor for more than 10
seconds to prevent the web from being
slackened.
(1) Take off the fuser unit
( P.13-17 "[B] Fuser unit").
(2) Take off the cleaning web unit
( P.13-18 "[C] Cleaning web unit /
Cleaning web").
(3) Remove 2 screws to take off the fuser unit
front cover.
Fig. 13-24
Fuser unit cover (front)
Screw
Screw