e-STUDIO555/655/755/855
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DRUM/CLEANER UNIT
10 - 12
(5) Take off the shaft of the separation finger by
sliding it to the front side.
(6) Remove 1 screw each to pull out the
separation finger from the shaft.
(7) Remove 1 E-ring and 1 screw, and then take
off the separation finger (in the middle) from
the shaft.
Fig. 10-21
Notes:
1. When assembling, be sure that the arm is
in the hole of the separation finger.
2. Make sure you assemble the drum
separation finger with the weight screws
in the correct direction.
3. Be sure to install the separation finger in
the correct position because the shape of
the separation finger in the middle and on
the outer side is different.
Fig. 10-22
Fig. 10-23
Separation finger
(1)
(2)
Pin
A
B
Hole
Pin
Hole
Weight screw
Weight screw