5
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO555/655/755/855
CONTROL PANEL
5 - 5
44
Select a paper size for
bypass feeding
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
45
Place the blank sheets in
bypass tray and select the
paper size
Displayed when no paper is in the
selected feeder at Cover Copying
Mode
46
Place the blank sheets in
the same direction as the
originals
Displayed when the direction of cover
page is different from that of other
pages at Cover Copying Mode
47
Place the same size blank
sheets as the originals
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
48
Place insertion sheets in
the bypass tray and select
the paper size
Displayed when no insertion sheet is
in the selected drawer at Sheet
Insertion Mode
49
Select the same size
insert1 sheets as the
originals
Displayed when the size of insertion
sheet (sheet 1) is different from that of
other pages at Sheet Insertion Mode
50
Select the same size
insert2 sheets as the
originals
Displayed when the size of insertion
sheet (sheet 2) is different from that of
other pages at Sheet Insertion Mode
51
Set insert1 sheets in the
same direction as the
originals
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
52
Set insert2 sheets in the
same direction as the
originals
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
53
Set transparency film in A4/
LT direction
Displayed when the selected paper
size is other than A4/LT at OHP mode
54
CANNOT PUNCH THIS
SIZE PAPER
Displayed when the selected paper
size is not specified for hole punching
55
Remove paper from the
finisher
Displayed when the paper sizes are
mixed at Staple Sorting Mode
56
Cannot staple this size
Displayed when the paper size is not
specified for stapling at Staple Sorting
Mode
57
Remove paper from the
saddle stitch unit
Finisher is full of papers
58
Examine stapler
Trouble in the stapler unit in finisher
59
Check staple cartridge
No stapler in finisher section
60
Check staple cartridge in
the saddle stitch unit
No stapler in saddle stitch unit
61
Job interrupted job 1 saved Interrupt copying is accepted
62
Ready to resume job 1
Interrupt copying is cancelled
(finished)
63
Cannot use AMS mode
Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Set the reproduction ratio 200% or
below manually
64
More than 200% is not
available
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Set the reproduction ratio 200% or
below
65
Updated the template
setting
Displayed when the template stored is
recalled by pressing [TEMPLATE]
button
66
Enter Department Code
Displayed when a button is pressed
while the department management
setting is available
No.
Message
State of equipment
Note