No. 2B771-004EN*M
2-8
CAUTION:
1. To prevent damage to the system, do not install it in a location where
it may be exposed to the following:
Direct sunlight
Sudden temperature fluctuations
Excessive dust
Excessive shock or vibration
High temperatures
High humidity
Poor air circulation because the system air filter is blocked by a wall
etc. (A space at least 10 cm wide and 20 cm deep is required.)
2. Do not disconnect the power plug while the system is starting up.
Doing so may cause the system to malfunction.
3. If either of the following phenomena occurs, press and hold down
for 5 seconds or more to turn OFF the power of the system.
The startup screen is not displayed after waiting for 30 seconds.
The patient registration screen is not displayed after waiting for
10 minutes.
If the power is not turned ON after holding down
for 5 seconds
or more, turn OFF the main power on the power panel.
Do not turn OFF the power in this manner during normal operation.
Doing so may cause the system to malfunction.
4. Do not press or use force on the main panel. Doing so may damage
the system.
5. The service outlets on the main unit provide power for recommended
external options only. Do not connect other devices to these outlets.
Doing so may result in the outlet power capacity being exceeded and
cause a system malfunction.
6. The cooling fan must be cleaned at least once a year. If the cooling
fan is clogged, the internal temperature will rise, shortening the
service life of the system. For inspection and cleaning by service
personnel, contact your TOSHIBA service representative.
7. If the main power switch on the power panel or circuit protector trips,
be sure to consult your TOSHIBA service representative. If the main
power switch is turned ON again before the problem is corrected, the
system or a connected device may sustain further damage.
Summary of Contents for Aplio 500 TUS-A500
