44
LX177 (E/F) Web 213:276
Chapter 5: Setting up your TV
Configuring the antenna input
source for the ANT terminal
To configure the ANT input source:
1
Press
Y
and open the
Setup
menu.
2
Highlight
Installation
and press
T
.
3
(A new set of
Installation
menu icons will appear, as
shown below.) Open the
Terrestrial
menu, highlight
Input Configuration
, and press
T
.
4
Press
C
or
c
to select the input source (
Cable
or
Antenna
) for the
ANT
input on the TV.
5
To save your new settings, highlight
Done
and press
T
.
To revert to your original settings, highlight
Cancel
and
press
T
.
Programming channels into the
TV’s channel memory
When you press
<
or
,
on the remote control or TV control
panel, your TV will stop only on the channels you programmed
into the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
Note:
•
You must configure the antenna input source before
programming channels (
-
at left).
•
If the Antenna input signal type is set to
Cable
, the automatic
channel programming process erases channels that were
previously programmed into the TV’s memory.
•
If the Antenna input signal type is set to
Antenna
, the
automatic channel programming process adds newly found
channels to the existing set of programmed channels (and
does NOT erase channels that were previously
programmed into the TV’s memory.) To remove an Antenna
source channel from the memory, you must manually delete
it.
•
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
•
Programming channels when the antenna input is
configured for
Cable
will take substantially longer than when
the antenna input is configured for
Antenna
. This is normal;
however, once channel programming is finished, you should
not have to repeat the programming process again unless
your Cable TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source, if you have not
already done so (
-
at left).
2
Press
Y
and open the
Setup
menu.
3
Highlight
Installation
and press
T
.
Setup
CE-Link Setup
Sleep Timer
HDMI Settings
PC Settings
Slide Show Interval
Demo Mode
Off
Installation
Power-On Mode
Power-Saving
2 Sec
Input Configuration
Terrestrial
Channel Program
Channel Add/Delete
Signal Meter
Installation
Input Configuration
Antenna In
Cable
Cancel
Done
Setup
CE-Link Setup
Sleep Timer
HDMI Settings
PC Settings
Slide Show Interval
Demo Mode
Off
Installation
Power-On Mode
Power-Saving
2 Sec
42LX177_EN.book Page 44 Tuesday, May 15, 2007 1:58 PM
Summary of Contents for 42LX177 - 42" LCD TV
Page 117: ...117 Notes ...
