44
Reference section
Troubleshooting
Before calling a service technician, please check the
following table for a possible cause of the symptom and
some solutions.
Symptom and solution
Why is there no sound or picture?
•
Check that the television is on and that all
connections are made properly.
Why doesn’t the video/DVD being played show on-
screen?
•
Make sure the VCR or DVD player is connected
to the television, then select the correct input by
pressing
.
Why is there a good picture but no sound?
•
Check all cable connections and that the volume
has not been turned down or that the sound has
not been muted.
What else can cause a poor picture?
•
Interference or a weak signal. Try a different
television station. Manual fine tuning may help:
1. Select the
ATV/DTV Manual Tuning
in the
SETUP
menu.
Highlight the station and press
, then press ◄ or
► to select Manual fine tuning.
ATV Manual Tuning
Manual Fine Tuning
1 Auto P
0
Back
RETURN
Change
Select
Save
OK
2.
Using ▲ or ▼ to adjust to get the best picture and
sound. Press
and then
EXIT
.
Why doesn’t the remote control work?
•
Check that the batteries aren’t dead or inserted
incorrectly.
Why are there problems with text?
•
Good performance of text depends on a strong
broadcast signal. If the text is unreadable or
garbled, check the aerial, satellite or cable
connection. Go to the main index page of the
text service and look for the User Guide. This will
explain the basic operation of text in some detail.
Why are the four coloured text numbers visible but
no text?
•
Text has been selected while viewing an external
source. No text will appear onscreen or a box may
appear stating no information is available. Select a
broadcasting channel and press
to access.
Why don’t the devices connected via HDMI operate
properly?
•
Make sure to use cables with the HDMI logo
(
). Some early HDMI equipment may not
work properly with the latest HDMI TV products,
due to adoption of new standards.
Why is the VCR/DVD picture in black and white?
•
Check the correct input has been choose AV or
YP
b
P
r
.
Why did TV turn off by itself?
•
After roughly 15 minutes without any input video
signal at TV mode, the TV will turn off to save
power.
Do not remember PIN. (See the PIN Setting menu
step1)
•
Use the Master PIN (code of 1276), then change to
a number of your choice. Ensure that no-one else
can use the Master PIN by removing the Owner's
Manual.
Reference section
Summary of Contents for 32AV800AZ
Page 50: ...1506 0GLM000 ...
