Cleaning
Removing Debris
Service Interval:
Before each use or daily
Important:
Operating the engine with blocked
screens and/or cooling shrouds removed will
result in engine damage from overheating.
1.
Park the machine on a level surface and lower
the loader arms.
2.
Shut off the engine, remove the key, and allow
the engine to cool.
3.
Open the hood and secure the prop rod.
4.
Clean any debris from the front and side
screens.
5.
Wipe away debris from the air cleaner.
6.
Clean any debris buildup on the engine and in
the oil cooler fins with a brush or blower.
Important:
Operating the engine with
blocked screens and/or cooling shrouds
removed will result in engine damage due to
overheating.
7.
Clean debris from the hood opening, muffler,
heat shields, and radiator screen (if applicable).
8.
Close the hood.
Cleaning the Chassis
Service Interval:
Every 100 hours—Check for dirt
buildup in the chassis.
Over time, the chassis under the engine collects dirt
and debris that must be removed. Using a flashlight,
open the hood and inspect the area under the engine
regularly. When the debris is 2.5 to 5 cm (1 to 2
inches) deep, clean the chassis.
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Raise the front of the machine so that the
machine is angled backward.
3.
Shut off the engine and remove the key.
4.
Remove the 2 bolts securing the bottom plate
and remove the bottom plate (
).
g031235
Figure 74
1.
Bottom plate
5.
Remove the front screen; refer to
Front Screen (page 27)
.
6.
Spray water into the chassis to clean out the dirt
and debris.
Note:
The water will drain at the back of the
machine.
Important:
Do not spray water into the
engine.
7.
Grease the machine; refer to
.
8.
Install the bottom plate (
9.
Install the front screen.
10.
Lower the machine.
48
Summary of Contents for TX 1000 Compact Tool Carrier
