Toro TX 1000 Compact Tool Carrier, Operator'S Manual

Page: 26 / 60

Removing and Storing the
Cylinder Locks
Important:
Remove the cylinder locks from the
rods and fully secure them in the storage position
before operating the machine.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Remove the pins securing the cylinder locks.
5. Place the cylinder locks on the posts on the
sides of the machine and secure with the pins.
6. Lower the loader arms.
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
Opening the Hood
1. Loosen the hood-locking screw ( Figure 32 )
g031215
Figure 32
1. Hood-locking screw 3. Hood
2. Hood-latch lever
2. Turn the hood latch clockwise ( Figure 32 ).
3. Lift up on the handles and swing the hood up
(
Figure 32 ).
4. Secure the prop rod.
Closing the Hood
1. Lift up on the tab securing the prop rod ( Figure
33 )
g031216
Figure 33
1. Prop-rod tab
2. Lower the hood and secure it by pushing down
on the front of the hood until it locks in place.
3. Tighten the hood-locking screw to secure the
latch (
Figure 32 ).
Opening the Rear-Access Cover
1. Remove the fastener ( Figure 34 ).
g031217
Figure 34
1. Fastener
2. Lift the rear-access cover up to access the
internal components (
Figure 34 ).
3. Lower the rear-access cover and install the
fastener to close the cover.
26