Toro TX 1000 Compact Tool Carrier, Operator'S Manual

Page: 31 / 60

4. Engage the parking brake, shut off the engine,
and remove the key.
5. Drain the oil beneath the platform ( Figure 45 ).
CAUTION
Components will be hot if the machine
has been running. If you touch hot
components, you may be burned.
Use care to avoid touching hot
components while changing the oil
and/or filter.
g031212
g029385
Figure 45
6. Remove the oil-fill cap and slowly pour
approximately 80% of the specified amount of oil
in through the valve cover.
7. Check the oil level.
8. Slowly add additional oil to bring the level to the
upper hole on the dipstick.
9. Replace the fill cap.
Changing the Oil Filter
1. Raise the loader arms and secure with the
cylinder locks; refer to
Installing the Cylinder
Locks (page 25) .
2. Engage the parking brake, shut off the engine,
and remove the key.
3. Remove the front cover; refer to Removing the
Front Cover (page 27) .
4. Drain the oil from the engine; refer to Changing
the Engine Oil (page 30) .
5. Place a shallow pan or rag under the filter to
catch oil.
6. Change the oil filter ( Figure 46 ).
g029749
Figure 46
7. Remove the oil-fill cap and slowly pour
approximately 80% of the specified amount of oil
in through the valve cover.
8. Check the oil level.
9. Slowly add additional oil to bring the level to the
upper hole on the dipstick.
10. Replace the fill cap.
11. Install the front cover; refer to Removing the
Front Cover (page 27) .
31