Toro TX 1000 Compact Tool Carrier, Operator'S Manual

Page: 41 / 60

g258146
Figure 61
1. Sprocket 4. Ratchet (1/2 inch)
2. Track 5. Road wheel (5)
3. Front wheel
9. Remove the 3 bolts securing the sprocket half
that is not engaged with the track (
Figure 61 ).
g257925
Figure 62
1. Bolt (3) 2. Sprocket half
10. Start the machine and disengage the parking
brake.
11. Move the traction control forward until the other
half of the drive sprocket is not engaged with
the track (
Figure 63 ).
g259736
Figure 63
12. Engage the parking brake, shut off the engine,
and remove the key.
13. Remove the track from the track frame.
14. Wrap the new track around the front wheel
(
Figure 61 ).
15. Push the track under and between the road
wheels and wrap it around the frame (
Figure 61 ).
16. Start the engine and disengage the parking
brake.
17. Move the traction control forward until the drive
sprocket half engages with the track (
Figure 64 ).
g259737
Figure 64
18. Engage the parking brake, shut off the engine,
and remove the key.
19. Apply thread-locking compound to the bolts of
the drive sprocket half that you removed and
install the sprocket half (
Figure 62 ). Torque the
bolts to 95 to 115 N∙m (70 to 85 ft-lb).
20. Using a 1/2 inch drive ratchet, turn the tensioning
screw counter-clockwise until the track deflection
is 12.7 mm (1/2 inch) as shown in
Figure 56 .
21. Align the closest notch in the tension screw to
the locking bolt hole and secure the screw with
the locking bolt, spacer, and nut.
22. Lower the machine to the ground.
23. Repeat the procedure to replace the other track.
41