Toro Sand Pro 5020, Service Manual

Page: 30 / 170

Throttle and Choke Controls
1
9
3
7
2
8 1
1
4
4
4
6
5
2
2
Figure 10
1. Knob 4. Cap screw 7. Hex nut
2. Throttle control 5. Dash Panel (SP 2020/3020) 8. Lock Washer
3. Lock nut 6. Right fender (SP 5020) 9. Choke control
Throttle Control Removal
1. Park machine on a level surface, lower attachment,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Pivot seat up. On the SP 2020/3020, remove the en-
gine shield.
3. On the SP 2020/3020 remove three hex flange head
screws securing the hood to the front shield (Fig. 11).
Remove four cap screws securing the dash panel to the
hood (Fig. 12). Remove hood from the machine.
Figure 11
1
3
2
1. Hex flange head screw 3. Front shield
4. Release throttle cable from clamp securing it to the
2. Hood
engine. Disconnect throttle cable from the swivel on the
engine (Fig. 13).
5. Remove throttle knob from the throttle control. Re-
move both lock nuts and cap screws securing the
throttle control to the dash panel or right fender. Remove
throttle control from the machine (Fig. 10).
1
1
2
3
Figure 12
1. Cap screws 3. Hood
2. Dash panel
Engine
Page 3 – 10
Sand Pro 2020/3020/5020