Toro Sand Pro 5020, Service Manual

Page: 35 / 170

Muffler (SP 5020)
Muffler Removal
1. Park machine on a level surface, lower attachment,
stop the engine, engage parking brake, and remove the
key from the ignition switch.
CAUTION
avoid possible burns, allow engine and exhaust
The muffler and exhaust pipe may be hot. To
system to cool before working on the muffler.
2. Access muffler from the rear of the machine. Re-
move muffler shield from the engine by removing three
cap screws and lock washers securing it to the engine
(Fig. 23 and 24).
3. Remove cap screws securing muffler and both gas-
kets to the cylinder heads. Pull muffler from the engine
(Fig. 24 and 25).
Muffler Installation
1. Replace gaskets if torn or damaged. Replace ex-
haust detector if worn or damaged.
2. Secure gaskets and muffler to cylinder heads with
cap screws (Fig. 24 and 25).
3. Secure muffler shield to the engine with three cap
screws and lock washers (Fig. 23 and 24).
1
2
Figure 23
1. Cap screw & lock washer 2. Muffler shield
1
2
3
5
4
4
6
7
8
6
Figure 24
1. Cap screw 5. Muffler
2. Lock washer 6. Gasket
3. Muffler shield 7. Screw
4. Cap screw 8. Exhaust deflector
Engine
2
2
1
Figure 25
1. Muffler 2. Cylinder head
Sand Pro 2020/3020/5020 Page 3 – 15 Engine