Toro Sand Pro 5020, Service Manual

Page: 33 / 170

Remote Air Cleaner (SP 2020/3020)
Remote Air Cleaner Removal
1. Park machine on a level surface, lower attachment,
stop the engine, engage parking brake, and remove the
key from the ignition switch.
2. Remove three cap screws securing the hood to the
front shield (Fig 19). Remove four cap screws securing
the dash panel to the hood (Fig. 20).
3. Loosen hose clamp. Remove air hose from the air
cleaner body (Fig. 21).
4. Remove both lock nuts, flat washers, and cap
screws securing the mounting band to the front shield
(Fig. 21).
5. Unlatch and remove cover from filter body. Sepa-
rate filter body from the mounting band. Make sure not
to drop the filter element (Fig. 21).
Remote Air Cleaner Installation
1. Insert filter body through the mounting band. Install
and latch cover to the filter body (Fig. 21).
2. Secure mounting band and air cleaner to the front
shield with both cap screws, flat washers, and lock nuts
(Fig. 21).
3. Secure air hose to the air cleaner with hose clamp
(Fig. 21).
4. Position hood to the front shield. Potion dash panel
to the hood. Secure dash panel to the hood with four cap
screws (Fig. 20). Secure hood to the front shield with
three cap screws (Fig 19).
1
3
2
Figure 19
1. Hex flange head screw 3. Front shield
2. Hood
1
1
2
2
Figure 20
1. Cap screws 3. Hood
2. Dash panel
Engine
2
4
3
5
6
1
Figure 21
1. Hose clamp 4. Lock nut & flat washer
2. Air hose 5. Mounting band
3. Air cleaner body 6. Cover
Sand Pro 2020/3020/5020 Page 3 – 13 Engine