Toro 09960, Operator'S Manual, Page: 54 / 92

3. Remove the lynch pin that secures the
depth-stop pin and spacers to the stop bracket
(
Figure 119 and Figure 120 ).
g342335
Figure 119
g342334
Figure 120
1. Lynch pin 4. Stop bracket
2. Thin spacer—6.3 mm (1/4
inch)
5. Depth-stop pin
3. Thick spacer—12.7 mm
(1/2 inch)
4. Position the spacers above or below the stop
bracket to adjust the coring depth.
•
With all spacers at the top of the stop bracket,
the depth setting is 10.7 cm (4-1/4 inches).
•
Thick spacers equate to 19 mm (3/4 inch)
increment.
•
Thin spacer equates to 9.5 mm (3/8 inch)
depth increment.
Note:
You must install all spacers, regardless
of their position.
5. Assemble the depth-stop pin and the spacers to
the stop bracket with the lynch pin.
6. Repeat steps 3 through 5 at the other side of
the machine.
Important:
Ensure that the spacer location
above and below the left and right stop
brackets are identical.
7. Install the coring-head cover; refer to Installing
the Coring-Head Cover (page 69) .
Setting the InfoCenter
Note:
If you aerate in manual mode, you must set
the InfoCenter for the manual ground following mode
each time you start the engine.
1. Turn the ignition key to R
UN
position.
Note:
Do not start the engine.
2. In the InfoCenter, navigate to the M
AIN
M
ENU
( Figure 121 ).
g358246
Figure 121
3. Press the center InfoCenter button until the
S
ETTING
option is selected, and press the right
button.
4. Press the center InfoCenter button until the
P
ROTECTED
M
ENUS
option is selected ( Figure
122 ), press the right button, and enter your
4-digit pin code (e.g. 1 2 3 4).
54