Toro 09960, Operator'S Manual, Page: 34 / 92

g357974
Figure 54
4. Press the center button to select the Set Spacing
option.
Note:
The Set Spacing screen displays.
5. Adjust the hole spacing ( Figure 55 ) as follows:
•
Press the InfoCenter center button to
decrease hole spacing.
•
Press the right button to increase hole
spacing.
g357977
Figure 55
6. Press the left InfoCenter button to save your
setting and exit the Set Hole Spacing screen.
7. Rotate the ignition key to the O
FF
position.
Setting Tine Diameter
1. Ensure that the coring head is raised; refer to
Raising the Coring Head (page 27) .
2. Rotate the ignition key to the R
UN
position.
g358601
Figure 56
3. Press the right InfoCenter button until the Setting
the Tine Diameter screen displays (
Figure 57 ).
g372377
Figure 57
4. Press the center button to select the Set
Diameter option.
Note:
The Set Diameter screen displays.
5. Adjust the tine diameter ( Figure 58 ) as follows:
•
Press the InfoCenter center button to
decrease tine diameter.
•
Press the right button to increase tine
diameter.
34