Toro 09960, Operator'S Manual, Page: 12 / 92

1
Installing the Rear Wheels
Parts needed for this procedure:
2 Wheel assembly
Procedure
1. At the rear of the machine, remove the 4 lug nuts
that secure the rear of the machine to brackets
of the shipping pallet.
2. Assemble a wheel assembly onto each
rear-wheel hub with the 4 lug nuts (
Figure 3 ).
g010018
Figure 3
1. Wheel assembly 2. Lug nut
3. Torque the lug nuts to 61 to 75 N∙m (45 to 55
ft-lb).
4. Repeat steps 1 though 3 at the other side of
the machine.
5. Deflate all tires to 83 kPa (12 psi).
2
Installing the Handle
Parts needed for this procedure:
1 Handle
3 Locknut (1/2 inch)
Assembling the Handle to the
Machine
1. Insert the studs at the end of the handlebar into
the holes in the steering arm (
Figure 4 ).
Note:
Have another person help hold the
handlebar.
g358119
Figure 4
1. Handlebar 3. Steering arm
2. Stud 4. Flange locknuts (1/2 inch)
2. Thread a flange locknut (1/2 inch) onto each of
the 3 studs.
3. Torque the flange locknuts to 91 to 113 N∙m (67
to 83 ft-lb).
4. Rotate the handlebar up and secure it with the
handlebar-latch pin (
Figure 5 ).
g342477
Figure 5
1. Handlebar-latch pin 3. Handlebar-latch knob
2. Detent plate
12