Toro 08839, Operator'S Manual

Page: 11 / 64

g374088
Figure 4
2. Align the link at the end of a short drawbar chain
to the hole in the chain tab of the rear frame
plate (
Figure 5 ).
Ensure the link is flush to the chain tab and the
next link aligns into the groove in the tab.
g361582
Figure 5
1. Flange locknut (5/16 inch) 4. Chain tab (rear frame
plate)
2. Washer (3/8 x 7/8 inch) 5. Carriage bolt (5/16 x 1
inch)
3. Short drawbar chain
(17-1/2 inches)
3. Assemble the chain to the chain tab with a
carriage bolt (5/16 x 1 inch), washer (3/8 x 7/8
inch), and flange locknut (5/16 inch) as shown
in
Figure 5 .
4. Torque the locknut to 19.8 to 25.4 N∙m (175 to
225 in-lb).
5. Repeat steps 2 through 4 for the other short
drawbar chain at the chain tab at the other side
of the machine.
Preparing the Rear Attachment
Adapter and Drawbar
1. Install the lift bracket to the rear frame assembly
as shown in
Figure 6 .
g392492
Figure 6
1. Flange locknut (5/16 inch) 3. Lift bracket
2. Rear frame assembly
crossbar 4. Carriage bolt (5/16 x 1
inch)
2. Install the tow-stop bracket to the drawbar with
a U-bolt and 2 flange locknuts (5/16 inch) as
shown in
Figure 11 .
Note:
Install the bracket with the tabs facing
the front of the machine.
g383944
Figure 7
1. Flange locknuts (5/16
inch) 3. Center bracket tab
alignment hole
2. Tow-stop bracket 4. U-bolt
11