Toro 08839, Operator'S Manual

Page: 15 / 64

Assembling the Rear Attachment
Lift Cylinder
1. Remove the cable tie that secures the rear
hydraulic cylinder and hoses to the back of the
machine.
2. Remove the carriage bolt and flange locknut
that secures the cylinder pin to the lift-shaft arm
(
Figure 16 ).
g361587
Figure 16
1. Carriage bolt 3. Cylinder pin
2. Lift-shaft arm 4. Flange locknut
3. Route the cylinder and hoses to the back of the
lift frame (
Figure 17 ).
4. Install the hose guard around the hoses 9 cm
(3.5 inches) from the rear tube channel as
shown in
Figure 17 .
Note:
Ensure that the extend and retract hoses
are not twisted around each other.
g361588
Figure 17
1. 9 cm (3.5 inches) from
the end of the rear tube
channel. 2. Hose guard
5. Assemble the rear attachment lift cylinder onto
the mount shaft of the rear frame (
Figure 18 ).
g374125
Figure 18
1. Attachment-lift cylinder 2. Mount shaft (rear frame)
6. Align the rod end of the cylinder between the
lift-shaft arms (
Figure 19 ).
g374126
Figure 19
1. Carriage bolt 4. Lift-shaft arm
2. Flange locknut
5. Cylinder pin
3. Rod end (attachment-lift
cylinder)
7. Secure the rod end to the lift-shaft arms with the
cylinder pin, carriage bolt, and flange locknut.
8. Lower the operator’s platform.
Note:
When the rear attachment-lift cylinder
is fully extended, the drawbar should be fully
raised against the rubber bumper.
15