Toro 08839, Operator'S Manual

Page: 35 / 64

Calibrating Mid-Mount
Attachment Stop
This procedure adjusts ground level reference point
for the attachment stop.
Preparing the Machine
Optional Mid-Mount Grader
Operator supplied: 2 wood blocks 38 mm (1-1/2
inches) thick
1. Move the machine to a level surface and engage
the parking brake.
2. If inserted remove the stop pins from the
following mid-mount attachment stop positions:
•
Transport and maintenance position
attachment-stop hole
•
Up-stop attachment-stop hole
•
Grade- or below-grade attachment-stop hole
•
Above-grade attachment-stop hole
g384311
Figure 49
3. Fully raise the mid-mount attachment; refer to
Raising the Mid-Mount Attachment (page 26) .
4. Tilt the multi-tool carrier backward ( Figure 50 )
until the tines are aligned higher that the bottom
of the grader blade; refer to
Tilting the Mid-Mount
Attachment Forward (page 27) .
g365617
Figure 50
35