9.
After moving the machine and before starting
the engine, close and tighten the bypass valves
for operation:
Important:
Do not start or run the engine
when the bypass valves are set to the open
position.
A.
Shut off the engine, remove the key, engage
the parking brake, and chock the wheels.
B.
Wait for all moving parts to stop and allow
machine components to cool.
C.
Close, but do not tighten, the bypass valve
by turning it approximately 2 full rotations
until it stops.
D.
Torque the bypass valve to 12.4 to 14.7
N
⋅
m (110 to 130 in-lb).
E.
Repeat step
to close the bypass valve on
the bottom of the other hydraulic pump.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death (
•
Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
•
Ensure that the length of ramp is at least 4
times as long as the height of the trailer or
truck bed to the ground.
40
