decal120-1686
120-1686
(Affix over Part No. 120-1683 for CE)
Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the
Operator’s Manual
as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1.
Warning—read the
Operator's Manual
; do not operate this
machine unless you are trained.
4.
Warning—do not park the machine on slopes; engage the
parking brake, lower the cutting units, shut off the engine, and
remove the ignition key before leaving the machine.
2.
Warning—read the
Operator's Manual
before towing the
machine.
5.
Thrown object hazard—keep bystanders away.
3.
Tipping hazard—do not turn at high speeds; do not drive
up or down slopes greater than 16°; do not drive across
slopes greater than 22°; lower the cutting units when driving
down slopes; use a roll-over protection system and wear
the seatbelt.
6.
Entanglement hazard, belt—stay away from moving parts;
keep all guards and shields in place.
8
Summary of Contents for 03820
Page 53: ...Notes ...
Page 54: ...Notes ...
