Service Interval Chart
decal133-4900
Figure 44
Pre-Maintenance
Procedures
Pre-Maintenance Safety
•
Before adjusting, cleaning, repairing, or leaving
the machine, do the following:
– Park the machine on a level surface.
– Move the throttle switch to the low-idle position.
– Disengage the cutting units.
– Lower the cutting units.
– Ensure that the traction is in neutral.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
– Allow machine components to cool before
performing maintenance.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Use jack stands to support the machine or
components when required.
•
Carefully release pressure from components with
stored energy.
Removing the Hood
1.
Unlatch and raise the hood.
2.
Remove the hairpin cotter securing the hood
pivot to the mounting brackets (
g008908
Figure 45
1.
Hairpin cotter
3.
Slide the hood to the right side, lift the other
side, and pull it out of the brackets.
Note:
Reverse the procedure to install the hood.
37
Summary of Contents for 03820
Page 53: ...Notes ...
Page 54: ...Notes ...
