©2020 TopXGun (Nanjing) Robotic Ltd,.Co Copyright owner
41
triggered;
3. Pitch or roll stick on the RC is pull/pushed;
4. When the drone enters the RTH mode;
5. When the drone has obstacle avoidance radar and have detected the obstacle leading
to an automatic brake;
6.
When the location signal or heading signal is weak, the drone will automatically exit
the operation mode and enter into the protection mode, and record the current
coordinate as the break point.
Notes:
1. Every time any one of the above conditions are met, the drone will update the break
point.
2. When the operation is paused and break point is recorded, the drone can perform the
following according to the situation : hover or rising by 2 meters and then hover.
2.5.2.3. Return To The Break Point
The steps for returning to the break point are as follows:
Step1：
Manually manipulate the drone to hover in any open place and ensure there is no
obstacle between this position and the break point.
Step2：
In the Plant Protection Assistant APP, tap the button "Return to the Break Point "
or tap the
Button.
Step3：
Select "Return to the Break Point" or "Return to the Projection Point" (return to
the operation route at the nearest possible junction by following a perpendicular line)
in the Plant Protection Assistant APP.
Step4：
The drone automatically rises or descends to the operating altitude and returns
to the break point.
Step5：
Resume the set route and continue the operation.
Notes:
1. For more detailed operation, please refer to the " User manual of Agriculture APP”.
2.5.2.4. Return To The Projection Point
When there is a obstacle on the way back to the break point, you can choose return to
projection point.
Step1.
After the operation is paused, you can manually fly the drone to bypass the
obstacle.
Step2.
Click the bottom right corner of the APP to continue the operation. Select
“
Return to the Projection Point
”
, and 1, 2, and 3 options will appear, corresponding
to no. 1, 2, and 3 points marked in the route.
