Form # 20011001
A
B
C
Rotating the arch assembly into its upright position is easiest when there is a crew of three (3) or more. Place the completed
arch with the intermediate brackets at the desired finish location and pick up the arch, as shown above, and rotate it to the
upright position. The person on the end rafter (C) pulls while the other two (2) lift the arch near the middle and work their
way out as the arch rotates into position.
CAUTION! Once the arch is upright,
one (1) person needs to steady it
(reference C) until the next steps
are complete.
A
B
C
Build the hip rafters out by installing the 4-way hip splices into upper rafters (A & B)
and quick pin. Then slip on the lower half of the hip rafter and quick pin as shown.
Tighten wing nuts to secure connectors to hip pole. Repeat this procedue on both
sides of this end frame assembly
Assembly Instructions
30 - 40 Wide
( 4 )
Raising Arch Assembly
Building End Frame
Step 8
Step 9
Step 10
Note: 30 Wide Future Trac tents do not have 4-way hip splices. The hip rafters are
single piece 21' 10" poles and once in place will steady the tent.
AIFT 30/40