Form # 20011001
Lifting Frame
Preparation is important at this time. Install anchoring points prior to raising the tent. At a minimum, install one anchor point
at each corner of the tent. Drive a stake out about four (4) feet from the frame location and attach a tie down strap or rope
between the frame and the stake. Pre-assemble legs to base plates and distribute to needed points prior to raising the tent.
A ssem bly Instr uctions
30 - 40 W ide
Place jacks at or near connection points (as shown). Put slings around the perimeter eave tubes and operate winch until the
slack is taken up on all jacks. One jack per section is required.
Caution!
Wind conditions can and will lift the entire tent. Proceed with
extreme caution and always lift with the top surface in the wind stream.
RATCHET STRAPS
BRACE BAR
BASE PLATE
LIFT
LIFT
LIFT
Working as a team, crank jacks to raise the tent side evenly and lift frame until it is above leg height, then install the leg with
base plates to the eave fitting and pin immediately with a 3/8" D-Clasp pin. Attach brace bar from rafter to leg (as shown
below), then lower tent jackslowly until the full weight of the tent is on its legs. Fasten top tie to leg bases (as shown).
Leg Installation
Installation of leg brace (prior to lowering jack).
Fasten top tie-downs to leg
( 11 )
AIFT 30/40
