Form # 20011001
Assembly Instructions
30 - 40 Wide
STEP 1:
Attach winch assembly to jack upright
as shown by placing winch assembly onto the
studs on the mast mounting plate. Install the
Ny-Lock nuts onto the studs and lock into place
with a 9/16" wrench.
STEP 2:
Install jack handle to winch assembly
by threading handle onto winch assembly.
STEP 3:
Install locking bolt, flat washer, spring
and spacer as shown to prevent handle from
coming off winch assembly while lowering. Lock
bolt must be tightened fully.
STEP 4:
Thread 2" strap through the roller
assembly as shown. Pull strap through support
pins on winch assembly. Rotate winch assembly
(raise direction) until the attaching bolt is facing
the outside. Route strap behind and under the
winch to align mounting hole with winch. Install
bolt and washer through grommet and tighten
fully with a 7/16" wrench.
STEP 5:
Remove third leg from its storage
location in the jack base and install with D-Clasp
pin (3/8") as shown.
STEP 6:
Attach jack upright as an assembly to
jack base as shown. Pin with D-Clasp pin (3/8")
to lock into place
( 16 )
AIFT 30/40
Appendix "A" - Jack Assembly
