Form # 20011001
QUICK PIN
QUICK PIN
QUICK PIN
Step 24
To build mid section and end frame, connect the two perimeter poles to the
completed half of the end frame. This will establish the location for alignment
of the last arch assembly.
Build arch assembly and raise in the same manner as in steps 1 - 9. Attach ridge
rafter as shown, using step ladder. Once ridge rafter is installed, attach
intermediates to perimeter poles as shown in the step above.
Build out the hip rafters as in step 10. Next, assemble the perimeter of the frame
starting at the intermediate bracket on one side of the remaining arch assembly. Attach
corner bracket as in step 12 and continue to attach the remaining components as in
steps 13 - 18.
View of completed frame, sitting on the ground, prior to
installation of tent tops or raising the frame onto it's legs.
D-CLASP PIN
Step 25
Step 26
Note: Leg brace bars have been
installed to reduce ladder work
during the final installation process.
Check all connections and fittings to be sure that the frame is ready to raise or to receive the tent top. All quick pins and D-
Clasp pins must be facing the same direction to prevent the fabric from catching on the pins when pulling the tops onto the
frame assembly.
( 9 )
AIFT 30/40
Assembly Instructions
30 - 40 Wide
