Form # 20011001
Next, attach an intermediate bracket with a
3/8" D-clasp pin as shown in the drawing
above.
Begin the assembly process, by attaching
the crown assembly to the Keder rafter as
shown using a 3/8" D-clasp pin.
Attach the opposite side Keder rafter to the
crown in the same manner as in the previous
step.
Repeat this procedure on the opposite side
intermediate bracket with a 3/8" D-clasp pin
as shown.
Step 1
Step 2
Step 3
Step 4
Important: Install the brace bar at the top of each arch. Slip
flat eye end into function slot of Keder rafter and pin with 3/8"
D-Clasp pin. Repeat prodedure for opposite side. It may be
necessary to move the rafter in or out to locate and pin this side.
Note: 30 Wide Future Trac tents will have a longer brace bar and
will be mounted lower on the Keder rafter however the installation
procedures will be the same.
Step 5
Cable - Straight (optional)
(Attaching Cable on Left Side)
Once the brace bar has been installed, connect one side of the cross cable with the clevis pin as show. Be sure that the pin is
installed so that it can be easily removed (if necessary). Attach opposite side using the same procedure as shown above. It
will require pulling the frame inward to install the clevis pin. This is a designed pre-load.
Step 6
Assembly Instructions
30 - 40 Wide
( 2 )
Building Arch Assembly
Cable Installation - 40 Wide Only
AIFT 30/40
