Contact Customer Service.
Alarm 9
Perform the initialization procedure.
Alarm 10
Contact Customer Service.
Alarm 11
Contact Customer Service.
Alarm 12
Pull & Go does not function
after the reset
Wait 10 seconds after termination of realignment.
Sensors do not activate the door
after the reset
Wait 10 seconds after termination of realignment.
The door loses its magnetic coupling
at the limit switch during learning
This is normal, there should be no problems during regular
operation.
The door opens rapidly and slams into
the limit switch
Perform the reset procedure again or call Customer Service.
The door opens normally but after three
openings closes slowly and at the fourth
signals the collision alarm
Make sure there are no obstacles in the passage space.
If necessary, clean the optical line or call Customer Service.
.
During the door movement the actuator
produces an unusual friction noise
Remove the actuator from the door and clean with a cloth
possible dust and dross from track and rotor.
Alarm 1
Perform the reset procedure and, if necessary, repeat
initialization.
Alarm 3
Alarm 5
Perform the initialization procedure.
PROBLEM
REMEDY
5.4
TROUBLESHOOTING
Perform the reset procedure and, if necessary, repeat
initialization.
Alarm 4
Perform the reset procedure
Allow the board to cool and perform the initialization procedure.
Alarm 6
Alarm 7
Perform the reset procedure and, if necessary, clean the
silkscreen printed guide on the rail with a damp cloth.
Alarm 8
Perform the initialization procedure.
31
M1
INSTALLATION AND USE INSTRUCTIONS
EN
Summary of Contents for M1
