PROGATE User manual V-2022-09-20
20 |
E N
SMS
OFF
ON
Remote Control
Pulse
OFF
ON
Remote Control
Level
SMS 1
SMS 2
OFF
ON
Remote Control
Pulse
Dial
OFF
ON
Remote Control
Level
Dial 1
Dial 2
System State:
Output for connection of light indicator of the alarm system
status. Within Exit Delay time a pulse signal is generated, and when the
alarm system activated
– continuous. Signal is terminated by turning off the
alarm system.
OFF
ON
System State
Open
Exit Delay
Close
Open
AC OK:
Output for connection of indicator about control panel supply
from alternating current
OFF
ON
AC OK
AC OK
AC Lost
AC OK
Ready:
Output for connection of light indicator of input statuses. If all zones
are clear (none violated), a continuous signal is generated.
OFF
ON
Ready
Zone Fault
Zone OK
Battery OK:
Output for connection of indicator about control panel supply
from battery.
OFF
ON
Battery OK
Battery OK
Battery Lost
Battery OK
Alarm indication:
Output for connection of light indicator showing alarm
status of the alarm system. After the alarm system actuation a continuous
signal is generated.
OFF
ON
Alarm Indication
Open
Close
Open
Alarm
Bell Time
Lost Primary Channel:
Output where a continuous signal is generated
when communication with primary channel was lost.
OFF
ON
Lost Primary
Channel
Lost Primary Channel
Restore Primary Channel
Fire Sensor Reset:
Output for reset of fire sensor operation. Its status
changes 5 sec. and returns to the initial one.
OFF
ON
Fire Sensor
Reset
Fire Sensor Reset
5 seconds
Lost Secondary Channel:
Output where a continuous signal is
generated when communication with secondary channel was lost.
OFF
ON
Lost Secondary
Channel
Lost Secondary Channel
Restore Primary Channel
5.1.3
Access control output with logging
If you want to edit existing configuration,
•
You have to read it (press “Read” in the command line)
•
Edit settings
•
Write edited configuration (press “Write” in the command line)
Set output definition to [
Access Gained
] . SERA2>Outputs
