PROGATE User manual V-2022-09-20
44 |
E N
8.2
The table of users SMS commands
If USER123456 commands are used, the phone number must be in the list of users
SERA2>
Users/ Access control
; if the phone
number is not in the list, SMS commands from this phone number will be blocked.
SMS configuration is allowed only with Latin characters. Unicode is not allowed.
Table 7 the table of user's commands
USER123456
˽020˽N
Change state of selected OUT output to the inverted state.
Output state changes every time after sending command code.
020= command code (Change state of selected OUT output to the inverted state.)
N = output number from 1 to 10.
USER123456
˽021˽N#ST
Activate or deactivate selected output N.
021= command code (Activate or deactivate selected output N)
N = output number from 1 to 10.
ST= output mode: 0
– deactivated output, 1- activated output
USER123456
˽022˽N#TIME#
Output activation for the time interval
022= command code (Output activation for the time interval)
N = output number 1-10
TIME = 0-999999 Time interval in seconds for the output activation.
USER123456
˽030˽ST
Change security system’s mode (ARM/DISARM/STAY/SLEEP)
030= command code (Change security system’s mode (ARM/DISARM/STAY/SLEEP)
ST = Security system mode 0-DISARM, 1-ARM, 2-STAY, 3-SLEEP
Enter user phone number in
the SERA2> Users/ Access control
list
USER123456
˽031˽ZN#BYP
Zone bypassing by sms command
031= command code (Zone bypassing)
ZN = zone number from 1 to 32
BYP= 1
– zone bypass 0- zone active.
USER123456
˽094˽TEL#SMS
SMS from the module forwarding to the other phone number
094= command code (SMS from the module resending to the other phone number)
TEL = phone number to which will be forwarded sms text
SMS = sms text that will be send to the referred phone number
USER123456
˽100 ˽N
System state request:
100= command code (System state request)
N = System state request type
1- System test request, Request information about the module (: IMEI, FW, LEVEL etc.)
2- the values of active sensors request
3 -Request about active zone states
4 -Request about output states
5 - System state request. The module will send information on input/output states and system state
(ARM/DISARM/STAY).
