18
The
RED
wire of the external receiver should be connected into the
“+24” (#11)
terminal.
Wired Keypad (24VDC) (optional)
The
RED
wire of the wired keypad should be connected into the
“+24” (#11)
terminal.
The
BLACK
wire of the wired keypad should be connected into the
“GND” (#12)
terminal.
The
PURPLE
wire of the wired keypad should be connected into the
“GND” (#14)
terminal.
The
BLUE
wire of the wired keypad should be connected into the
“OSC” (#15)
terminal.
Electric Lock (optional)
The electric lock should be wired to the
“LOCK” (#7) and “GND” (#8”)
terminals, no matter the polarity of
the wires.
Exit Wand (optional)
The
BLACK
wire of the exit wand should be connected into the
“GND” (#9)
terminal.
The
BLUE
wire of the exit wand should be connected into the
“OPSW” (#10)
terminal.
The
RED
wire of the exit wand should be connected into the
“+24” (#11)
terminal.
The
GREEN
wire of the exit wand should be connected into the
“GND” (#12)
terminal.
The sensitivity adjustment board should be wired to the
GREEN
wire and the
YELLOW
wire of the wand.
No matter the polarity.
HomeLink Remote Control Kit (optional)
The
“1”
terminal should be connected to the
“GND” (#14)
terminal.
The
“2”
terminal should be connected to the
“OSC” (#15)
terminal.
The
“DC+”
terminal should be connected to the
“+24” (#11)
terminal.
The
“DC-”
terminal should be connected to the
“GND” (#12)
terminal.
How to Program or Erase the Remote
The remote MUST be programed to the opener BEFORE OPERATING. Please follow the steps to
program the remote.
Activate the opener only when gate is in full view, free of obstruction and properly adjusted. No
one should enter or leave gate area while gate is in motion. DO NOT ALLOW CHILDREN to
operate push button or remote. DO NOT ALLOW CHILDREN TO PLAY NEAR THE GATE.
If you purchase additional remote controls, the gate opener must be programmed to accept the
new remote code.
If you lose one of any remote control, please erase and reprogram all other remote controls to
have a new code for safety.
Program the remote
Press and release the learn button, the
LED
will display
“Ln”,
then press
the key on the remote
two times
in 4 seconds,
between the two times
HOLD ON FOR A MOMENT
, the
LED
will flash
“Ln”
for 4 seconds then
back to
“- -”
. Now the remote has been programed successfully.
Erase all the remote codes
Press and hold the learn button until the
LED
display “dL”, release the
Summary of Contents for CASAR HJ4021
