Topcon Pocket-3D, Reference Manual, Page: 241 / 316

Measure Points
P/N 7010-0628
4-15
Figure 4-22. Topo-shot Options
On the Control pt tab,
select the minimum requirements for control
point measurements, then press
Ok
(Figure 4-23).
• Duration (secs) – enter the minimum time in seconds desired for
each control point measurement.
• H. Precision – enter the minimum horizontal precision desired for
each control point measurement.
• V. Precision – enter the minimum vertical precision desired for
each control point measurement.
Figure 4-23. Control Point Options
On the Roving tab,
enter a roving accuracy limit for the horizontal
and vertical RMS value, then press
Ok (
Figure 4-24 on page 4-16).
• H. Precision – enter a limit for the horizontal RMS value.
• V. Precision – enter a limit for the vertical RMS value.