Tomey AL-2000, Operator'S Manual

Page: 80 / 119

AL-2000 Biometer & Pachymeter
71
7 7..5 5 G Ge en ne erra all U Uttiilliittyy S Se ettu up p
7 7..5 5..3 3 D Da atta a C Co om mm mu un niicca attiio on n P Po orrtt ((R RS S--2 23 32 2C C))
a a.. P Piin n p po ossiittiio on nss o off tth he e R RS S--2 23 32 2C C cco on nn ne eccttiio on n tte errm miin na allss
Measured data may be transferred to a comput-
er via a data communication port (RS-232C).
Follow these steps to attach an RS-232C com-
munication cable:
1. Insert the connector adapter (1) to the RS-
232C connection terminal (2) on the back of
the instrument and secure the connection by
tightening the screws.
2. Connect the RS-232C communication cable (3)
to the adapter and secure the connection by
tightening the screws.
Accessory equipment connected to the RS-232C
interface must be certified according to the
appropriate IEC 60601-1 standard for medical
equipment. Furthermore, all configurations must
comply with the IEC 60601-1 system standard.
Anyone who connects additional equipment to
the signal input port or signal output port is con-
figuring a medical system and is, therefore,
responsible for assuring that the system com-
plies with the requirements of the IEC 60601-1
system standard. If in doubt, contact the Tomey
technical service department or your local Tomey
representative.
RxD: Receive data
TxD: Transmit data
DTR: Data terminal ready
SG: Signal ground
DSR: Data set ready
RTS: Request to send
CTS: Clear to send