Tomey AL-2000, Operator'S Manual

Page: 74 / 119

AL-2000 Biometer & Pachymeter
65
7 7..4 4 U Uttiilliittyy S Se ettu up p ffo orr P Pa acch hyym me ettrryy
7 7..4 4 U Uttiilliittyy S Se ettu up p ffo orr P Pa acch hyym me ettrryy
7 7..4 4..1 1 M Ma ap p cco on nssttrru uccttiio on n
For the map measurement mode, the meas-
uring locations and the order in which the
measurements are taken should be pre-set.
Two maps, MAP 1 and MAP 2, may be con-
structed.
To construct MAP 1 and MAP 2:
1. Touch the M Ma ap p C Co on nssttrru uccttiio on n key (1) on the
pachymetry Utility screen (fig. 1) to display
the map construction screen (fig. 2).
2. Touch the M MA AP P 1 1 key (2) to select MAP 1.
The key for the selected map is reverse
highlighted.
3. To delete the pre-set map, touch the A A--
C Clle ea arr key (3). In the event that you have
accidently deleted or wish to stop delet-
ing, touch the C
Ca an ncce ell key (4) to restore the
previous map.
4. Consecutively touch as many elements (5)
as you want to measure in the order that
you want to measure them. The selected
elements will be reverse highlighted. The
numbers in the boxes indicate the measur-
ing order. Non-selected elements are
blank.
5. If you wish to remove an element, touch it
again. In the event of an erroneous
removal, touch the C
Ca an ncce ell key (4) to
restore the previous selection.
6. After the elements have been selected,
touch the O
OK K key (6) to register the map.
7. Touch the M MA AP P 2 2 key (2) and repeat steps
3-6 to construct Map 2.
8. When map construction is complete,
touch the M Ma ap p C Co on nssttrru uccttiio on n key (7) to
return to the pachymetry Utility screen
(fig. 1).