Tolomatic Hardware & Installation Guide:
ACS Drive/Controller
• 5-5 •
5:
c o n n e c t i o n s & c a b l e s
PIn nUMBERS
SIGnAl
1
Main Power +24Vdc
2
Keep Alive +24Vdc
3
NA
4
Ground – Power
Table 5-7: Input Power pinouts
CABlE
InPUt POwER MAtInG COnnECtOR
Customer Supplied
OnShore PN: ED950/4
Table 5-8: Input Power Cable Parts
The RS-232 port connector is a standard RJ12 type connector and will mate with
standard RJ12 connectors and cables.
Figure 5-8: RS-232 Connection
The ACS Drive uses five signals from the RS-232 port and will need to be properly
wired to the pin diagram shown below. RS-232 baud rate is set at 38400 bps,
1-stop bit, no parity and no flow control. The RS-232 cable itself is a straight
through cable.
PIn nUMBERS
dESCRIPtIOn
2
TX
3
RX
4
Programming
5
Ground
6
Reset
PIN 1
SHIELD
Table 5-9: RS-232 pinouts and Connection
5.6 RS-232 Connection
1
