Tolomatic Hardware & Installation Guide:
ACS Drive/Controller
• 4-2 •
4:
A C S D r i v e / C o n t r o l l e r S e t u p
4.1.1 Setup Procedures
1. Install drive/controller and actuator into appropriate fixtures.
2. Wire the 24Vdc power supply to the drive. See Section 6: Power Supply
Selection.
3. Wire input and output signals to the desired logic device. See Section 5:
Connections and Cables.
4. Attach motor and encoder cables.
5. Attach serial programming cable and install the Tolomatic Motion Interface
software.
6. Configure ACS Drive.
7. Program the logic device.
