12
⑥
Common parameter setting mode
- This mode will set the parameter common to each pattern and step.
From reset mode
Hold the
△
key and the PATT./STEP
key down for 5 seconds
simultaneously.
Set the PV correction zero point.
Set the PV correction gain.
Set Forward action or Reverse action.
:Forward action (cooling) /
: reverse action (heating)
Press the PATT./STEP key.
Switch between sensor types.
:
K thermocouple /
: J thermocouple /
: R thermocouple
: T thermocouple /
: N thermocouple /
: S thermocouple
: B thermocouple /
: Resistance temperature detector
Set "SV limiter upper limit setting".
Set "SV limiter lower limit setting".
Set the number of patterns.
Select PV or SV start.
: PV start1 /
: PV start2 /
: SV start
Set the control start temperature when SV start is selected.
(This will not be displayed at PV start.)
Set "Main output proportional cycle setting".
It is hidden when the main control is selected to "ON / OFF control".
Set "Sub-output proportional cycle setting".
It is hidden when the sub-control is selected to "ON / OFF control or none".
Set "weight zone setting".
Set "wait time setting".
Set "Time signal or Event Output 1 type setting".
PV
SV
[A]
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Set "Run Output or Event Output 2 type setting".
PV
SV
Press the PATT./STEP key.