11
⑤
Programming mode
- This mode will set the program for each pattern.
- Setting the time to 0 minutes will invalidate that particular step.
From reset mode
Hold PATT./STEP down
for 3 seconds.
From operation mode
Pattern number setting mode
Hold PATT./STEP down
for 3 seconds.
Set step 1 temperature.
Press PATT./STEP.
Set it to values up to the maximum
step. (This varies according to the
number of patterns.)
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
Set step 1 time.
Set step 2 temperature.
Set step 2 time.
Set step 3 temperature.
Set step 3 time.
Set step 4 temperature.
Set step 4 time.
Set step 5 temperature.
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
Set step 5 time.
Set step 6 temperature.
Set step 6 time.
Set step 7 temperature.
Set step 7 time.
PV
□
SV
PV
□
SV
Set step
□
temperature.
Set step
□
time.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
Press the PATT./STEP key.
- If you press the [
▽
] key when the temperature setting for each step is the minimum value in the
setting range, " " will be displayed, and on or after the set step, it will be invalid and the setting
parameters will not be displayed. The operation ends at the step before the step set as " ".
- In changing a setting during operation, you cannot change the step temperature or step time during
operation.
- If you press the [
▽
] key when the temperature setting in step 1 of each pattern is the minimum
value in the setting range, "
" will be displayed, and timer operation will be performed in step
1 of the set pattern. For details, refer to "4.8. Timer operation function".
- If all steps are set to their initial values (0°C), setting a temperature will automatically set the next
step to the same temperature as well.
- Setting a step time to a value higher than the maximum in the setting range (displayed as "
")
will cause the product to run continuously at the set temperature in that particular step.