3-7
Chapter 3
OPERATION
1.3.6. Example of general EV broadcasting
Here, an operation example based on the zone patterns is explained.
Step 1. Press the function key R1 (Zones 1, 2, and 3).
All the set zones are selected, and the zone
selection indicator of the function key R1 lights
green.
Note
To cancel the selection, press the function key R1
again or the function key R5 (Zone clear).
The selection indicator goes off.
Step 2. Press the function key R7 (General EV
broadcast).
General EV message is broadcast to the
selected zones.
The Zone selection indicator of the
function key R7 lights green, and the
Broadcast status indicator lights yellow.
Also Broadcast status indicators of the
function keys R1, R2, R3, and R4 flash
green.
Broadcast status indicator
Zone selection indicator
Function key
R1
(Zone 1, 2 and 3)
Green
R1
(Zone 1, 2 and 3)
R2
(Zone 1)
R3
(Zone 2)
R4
(Zone 3)
Flashes green
Lights yellow
Green
Function key
R7
(General EV broadcast)
1.3.7. Example of zone volume adjustment
[When increasing the volume level of the preset zone]
Step: Press the function key R8 (Zone 1 volume up) several
times until the volume becomes the desired level.
Each time the key is pressed, the volume level of the
set zone or that of the zone pattern increases by the set
amount.
The volume indicator lights green when the volume level
becomes greater than the initial value* of that zone.
[When decreasing the volume level of the preset zone]
Step: Press the function key R9 (Zone 1 volume down) several
times until the volume becomes the desired level.
Each time the key is pressed, the volume level of the set
zone or that of the zone pattern decreases by the set
amount.
The volume indicator lights green when the volume level
becomes smaller than the initial value* of that zone.
Volume indicator
Function key
R8
(Zone 1 volume up)
Green
Volume indicator
Function key
R9
(Zone 1 volume down)
Green
* Volume set in "Sound settings (output)" of the VX-3000 Setting Software.
