ENGLISH – Tiki medical
29
4.2 Use with the external battery
1. Before use, charge both the internal and the external battery
2. If the indicator light on the battery charger is red, the battery is charging
3. If the indicator light on the battery charger is green, the battery is fully charged,
refer to figure 2.
4. At the moment that both the internal and the external battery are fully charged,
perform the following:
a. Pull the charging cable through the tri-glide on the harness to make sure the
cable has a strain relief and that it proceeds backwards behind the user.
b. Remove the screw seal or red tape on the top left of the mask
c. Insert and screw the cable of the external battery to the internal battery,
making sure to observe that the pin configuration’s meet, refer to
figures 3 and 8
d. Connect the cable to the external battery
5. Use the Tiki medical mask as to the below procedures
6. After use, unscrew the cable from the internal battery, refer to figure 3.
Do not leave the external battery connected to the internal battery when the mask
is not in use.
If not disconnected, the batteries discharge rapidly.
7. Note that the red tape or screw seal in step 4a is to be applied again if the Tiki
medical mask is to be used with the internal battery only again,
refer to paragraph: 1.4 Prepare the Tiki medical mask on page 7
