Audio DSP with AEC, 4-in/4-out analog, 4-in/4-out Dante and USB
-11-
Power Source:
Power connector: 12V DC / 2A
Dante/PoE
100 Base-T Ethernet connector, provide up to 8 (4x4) channel Dante network audio. Uses the UltimoX4 chip. This interface is
also used for communication with PC software and any third-party external controller.
Dante
100 Base-T Ethernet connector, switched network interface (not for redundant Dante use)
RS485
Used for the serial communication port Tx = sending or data output or Rx = receiving or data input that
connects to a third-party control device.
RS485 can be used for voice tracking control (or other output commands), or for bus input control. A
central command can be used to conveniently integrate it into your software.
Port setting: 115200 baud (default), 8 data bits, 1 stop bit, no parity, no flow control.
RS232
Used for serial communication with external devices. Port Tx = sending data, and Rx = receiving data
input from a third-party control device.
Port setting: 115200 baud (default), 8 data bits, 1 stop bit, no parity, no flow control.