Audio DSP with AEC, 4-in/4-out analog, 4-in/4-out Dante and USB
-13-
Click “Connect” to match the device on the network with the unit in the open tab in the software. One processor supports
simultaneous connection and control of up to four users.
In the “Device List” menu there are also settings for assigning static IP-address.
3.3 Audio Parameters
There are two modes for parameter editing:
•
Click the input or output channel modules and enter the parameter interface of the module.
•
Right click the module and the configuration interface will pop out. The first mode is adopted for the following module
parameters.
3.3.1 Input Source
Sensitivity:
Input gain in nine steps (0/6/12/18/24/30/36/42/48dB).
Phantom Power:
Pr48V DC power for condenser microphones. Do not enable phantom power for a line input or when
the power is not required, as this may damage the external device.
Sine Wave:
Click to activate tone generator. Drag the frequency slider to set frequency (20~20 kHz). Drag level slider to adjust
output level (unit: dBFS). Use the slider or click the text field to set a value.
White Noise:
Click to activate White noise generator. White noise has a flat frequency spectrum. Use level slider to adjust level.
Frequency slider has no function in this mode.
Pink Noise:
Click to activate pink noise generator. Pink noise falls off by 3dB/octave. Use level slider to adjust level. Frequency
slider has no function in this mode.
Right click to copy/paste parameters between channels
Right click/Group Setting:
Open the group setting interface swiftly.
Right click/Minimum and Maximum Gains:
Limit the maximum and minimum of the gain of a channel.
