Tico Pro-Spotter, Service Manual

Page: 158 / 211

13-4 Service Manual
TICO Manufacturing
CAB PRO-SPOTTER
Figure 13-2: Cab Latch (right side shown)
3. Apply alignment marks to cab frame and cab air bag
(6) to aid when adjusting.
4. Loosen lock nuts (5).
5. Adjust cab air bag by repositioning cab air bag on the
cab frame as necessary.
6. Tighten lock nuts.
7. Slowly lower cab. Check alignment between cab air
bag striker and cab latch. (See “CAB LATCH” on
page 13-7.)
Removal
See Figures 13-3, 13-4, 13-5, and 13-6.
NOTE
Removal of the left side cab air shock is shown. Right
side cab air shock procedure is similar.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
Figure 13-3: Lock Bar
2. Raise cab completely and allow it to settle into detent
position 1 (full open) (1) of the lock bar (4).

CAUTION
3. Release air system pressure. (See “RELIEVING AIR
SYSTEM PRESSURE” on page 8-6.)
5 Lock Nut (4 used) 6 Cab Air Bag
5
TPS-150
6
1 Detent Position 1 (full open) 3 Detent Position 3 (minimum
open)
2 Detent Position 2 (half
open) 4 Lock Bar
• Avoid personal injury from explosion. Air
system components may contain pressurized
gases. Exposure to excessive heat may
cause components to explode.
• Avoid personal injury from high-pressure
gases or debris. High-pressure release of
gases or debris from a pressurized system
can cause penetrating injuries. Relieve
system pressure from air system before
servicing.
TPS-083
1
2
3
4